butric Posted December 16, 2015 Share Posted December 16, 2015 Hello, Been having some frustrating issues with my CTB16D board. Since just today, I walked outside to see that my stand alone sequence was not running properly. Instead, channels 1, 3, 5, and 14 were flashing in a random, rapid fashion. Also, upon inspecting the controller, the status led was off. No flashing, no solid red, just off. The only way I could get the controller back up and running was by resetting it by setting its address to 00 and applying power. Then the status LED flashed like it normally would if it has no connection. (because it was not connected at this time to a showtime computer). Is this a known issue? Firmware? IF i'm forgetting to cover anything ask away. current firmware is 1.0.4 At your leisure. Thanks Link to comment Share on other sites More sharing options...
Recommended Posts