Axeltheblack05 Posted September 15, 2013 Share Posted September 15, 2013 (edited) Just purchased a Servo Dog to play around with some servo ideas I had, but I cant get the darn thang to control the servos. I noticed that the manual says it sould be blinking at me twice a second but its doing somthing diferent the led constant on and turns off then right back on once every 2 seconds any idea what that means? Edited September 15, 2013 by Axeltheblack05 Link to comment Share on other sites More sharing options...
EARLE W. TALLEY Posted September 15, 2013 Share Posted September 15, 2013 Reload the firmware and see if that helps. Link to comment Share on other sites More sharing options...
Axeltheblack05 Posted September 15, 2013 Author Share Posted September 15, 2013 ok reloaded the firmware now the servo dogs led blinks swice a second when not conected to the computer and is solid on when conected like it should be but it still does not move the servos Link to comment Share on other sites More sharing options...
Axeltheblack05 Posted September 15, 2013 Author Share Posted September 15, 2013 ok after I powered off the controler and powered it up again it works and controls the servos fine Link to comment Share on other sites More sharing options...
Recommended Posts