Can a CF50D (flood) be configured as a prop in the Pixel Editor

[futuretechguy]

I have the (CF50D) 50 Watt Cosmic Color Flood successfully configured in the Sequence Editor but I need to move it to the PE as a prop (all but two of my props are sequenced in the PE)) but I can't seem to get it to work. It is manually set (DIP Switch) to LOR ID13 (DMX Start 19)  and so far all the combinations have not worked, I tried LOR with one bulb and a channel for each color as in the SE.

 

Can someone point me in the right direction please.

[Dennis Laff]

Did you setup as a rgb dumb in pixel editor Then select bulb. In props then flood and expand bulb size in preview layout. Add universe and start channel

[futuretechguy]

I believe I did try that, but I will test that configuration again.

[Dennis Laff]

are you using in dmx or lor mode do have the jumpers set correct for the mode your using ?

[futuretechguy]

I tried both modes and the jumpers are 5,8 and 9 "ON" which I believe is Unit ID 13 Start Universe 19

[Dennis Laff]

does it light in sequence editor but not in pixel editor

[futuretechguy]

Yes

[Dennis Laff]

if you run in lor mode in the pixel editor the flood needs to be on a enhanced network in network preferances and has to have the latest firmware,  all lor controllers need to be on enhanced network for the pixel editor to control lights if your in dmx mode they will turn on in the pixel editor.

[futuretechguy]

Thanks, I have a gen3 LOR Controller so I can enable Enhanced mode.