Paul Masterson Posted November 24, 2019 Share Posted November 24, 2019 Hi I recently bought a PixCon16 and ran a few tests a few months ago and all looked great. I finished zip tying all the ribbons to the tree and now when I run the sequences, my colors are all off. Grinch (who is green of course) is all red and so on. With one week to set-up time, I'm struggling to find out what happened to the set-up. Anyone have something similar occur and have a resolution or willing to walk through a setup with me? thanks Link to comment Share on other sites More sharing options...
Mr. P Posted November 24, 2019 Share Posted November 24, 2019 Go into the HU and test the RGB color order, you may have to go into the Pixie set up and change the order. Link to comment Share on other sites More sharing options...
Paul Masterson Posted November 25, 2019 Author Share Posted November 25, 2019 @Mr. P - You are right. Oddly, I had to change the colors to GBR in order for them to match the colors in the sequences. That makes zero sense to me but we are good to go now. Thanks for the guidance.. Link to comment Share on other sites More sharing options...
TheDucks Posted November 25, 2019 Share Posted November 25, 2019 41 minutes ago, Paul Masterson said: @Mr. P - You are right. Oddly, I had to change the colors to GBR in order for them to match the colors in the sequences. That makes zero sense to me but we are good to go now. Thanks for the guidance.. The order is how the string nodes were built. The controls (data stream) must match the target. Link to comment Share on other sites More sharing options...
Recommended Posts