worksopian Posted April 25, 2014 Posted April 25, 2014 I have a question regarding adding a CCB to the sequence editor. When i initially add the device to the editor, i see 2 new black lines as i would expect to see. After creating arches in the Visualizer and going back to the sequence editor I find 600 plus regular channels assigned to the CCB and no black RGB channels.How do I fix this? What did I do wrong? Thanks in advance for your help.
worksopian Posted April 26, 2014 Author Posted April 26, 2014 I didn't find out what I did wrong but did fix my issue. The problem was specific to one sequence. So I copied the channel config from another one I had been working on and that cured my problem. Needless to say, i backed up the good channel config and saved it in multiple places.
George Simmons Posted April 26, 2014 Posted April 26, 2014 I don't know where you might have gone astray, but you're on the right track by keeping what works and getting rid of things that are screwed up. If you had over 600 channels that sounds like you set up two sets of 100-bulb CCBs. One set of CCBs with 100 lights will only be 300 channels (plus the macro channels).
Recommended Posts