Andrew Bev Posted January 26, 2012 Share Posted January 26, 2012 I made the spinners using 20mm pvc conduit. I used a 20mm 4way deep junction box in the center and drilled the 4 extra holes. I also drilled a 32mm hole in the bottom of the deep junction box and used 32mm conduit as the main pole support, this also fits nicely over our standard T.V antenna roof mounts.Each section of the spinner is cut into 700mm sections and the bottom 2 sections were 400mm each. I thought the 2 smaller sections worked well as a good lenght for the bottom of the cross.You can check out my demo video here You can also check out some more photos on my web site here http://tamborinechristmaslights.webs.com/apps/photos/album?albumid=12494826I hope this is helpful. Attached files Link to comment Share on other sites More sharing options...
Andrew Bev Posted January 26, 2012 Share Posted January 26, 2012 I made the spinners using 20mm pvc conduit. I used a 20mm 4way deep junction box in the center and drilled the 4 extra holes. I also drilled a 32mm hole in the bottom of the deep junction box and used 32mm conduit as the main pole support, this also fits nicely over our standard T.V antenna roof mounts.Each section of the spinner is cut into 700mm sections and the bottom 2 sections were 400mm each. I thought the 2 smaller sections worked well as a good lenght for the bottom of the cross.You can check out my demo video here You can also check out some more photos on my web site here http://tamborinechristmaslights.webs.com/apps/photos/album?albumid=12494826I hope this is helpful. Link to comment Share on other sites More sharing options...
Andrew Bev Posted January 26, 2012 Share Posted January 26, 2012 I made the spinners using 20mm pvc conduit and a 20mm 4way deep junction box and I drilled out the other 4 holes between the 4 oulets. I also drilled a 32mm hole at the bottom of the junction box and used 32mm conduit as the main support and it also fits straight over our T.V antenna mounts.Each section of the spinner is cut into 700mm sections and the bottom 2 sections I made 400mm long each as I found this was a good lenght for the cross.Here is my demo of the spinner when I first made one There is also a few photos on my web site here http://tamborinechristmaslights.webs.com/apps/photos/album?albumid=12494826I hope this helps. Link to comment Share on other sites More sharing options...
Recommended Posts