dougd Posted January 17, 2012 Share Posted January 17, 2012 geronc wrote:dougd wrote: I have a total of 16 sets of the 36 count. Looks like I will need at least a 20 amp power supply.Is there a way to control these lights with LOR S3 right now? Sounds like the E681 is the way to go, but I hate relying on something the software doesnt yet support.LOR is saying they will have something out the first half of this year that will support the E681 which is the E1.31 DMX Protocol. I'm moving foward with programming for it. When they release it, I will just make the adjustments needed to send the commands to the E681. Life will be good.Good advise. I have been playing around with adding RGB channels to S3. If trying to start programming now, what would be some good advise in setting up the channels to do the least amount of fixing later on? What settings are you using when setting up the channels. Link to comment Share on other sites More sharing options...
geronc Posted January 17, 2012 Share Posted January 17, 2012 Just treating them like a DMX channel for an Enttec Pro right now. Hopefully that will make it easy when they add E1.31, since they are both DMX Link to comment Share on other sites More sharing options...
Recommended Posts