Jump to content
Light-O-Rama Forums

2 bad spots on board....


Recommended Posts


ran a few test this last week and had one channel that wanted to stay on, then that turned to 2 channels that would stay on if power was supplied to the LOR

reset with no results
decided to just unplug it and make do for now

well ran the show today and noticed 2 other channels were off:(

went to do another reset on the controller and the #9 and #10 channel where it comes from the board were scorched :shock:

this controller runs almost all LED lights so I am way under the amp per channel/controller spec

Any ideas?

Link to comment
Share on other sites

This topic is now closed to further replies.
  • Create New...