Jump to content
Light-O-Rama Forums

Problem with CMB16D DC controller


Kim

Recommended Posts

I tried to set max intensity range to 86% using HWU, but couldent see any difference. But now it acts like the min. intensity range is set to 10% so all connected LED's is slightly on all the time. If i reboot my PC, they turn 100% off but as soon as i start a sequence, they go to 10% again! Tried to flash the older firmware (1.20) but its the same! Its running on 24 volt from two car batteries.

How do i reset that setting?

/Kim

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...