Larry Johnson Posted October 6, 2023 Share Posted October 6, 2023 Please help, I am using a Gen 3 CBT16 PC controller as my first in the line, and older legacy controllers daisy chained to it. I tried using regular and enhanced I can see all my units in the UH screen but when running a sequence only the Gen 3 unit controls. Any advise would be greatly appreciated Thanks Larry Link to comment Share on other sites More sharing options...
TheDucks Posted October 6, 2023 Share Posted October 6, 2023 (edited) You can't use Enhanced on the same network as Legacy units. You do not really need enhanced until really high channel counts (smart nodes are 3 channels EACH) Another issue is speed. 115K is about tops Edited October 6, 2023 by TheDucks 1 Link to comment Share on other sites More sharing options...
Larry Johnson Posted October 6, 2023 Author Share Posted October 6, 2023 Thanks, I will try to lower the speed Link to comment Share on other sites More sharing options...
rmturner54 Posted January 9 Share Posted January 9 I figured that out the hard way this year with my director. When creating my SD card for this year, I just blew right by the network setting when doing so. The program defaulted to LOR/ELOR instead of LOR. Neever even pair attention to it, just hit next. Boy.....did that cause problems. On 10/6/2023 at 5:17 PM, TheDucks said: You can't use Enhanced on the same network as Legacy units. You do not really need enhanced until really high channel counts (smart nodes are 3 channels EACH) Another issue is speed. 115K is about tops Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now