Pixcon 16 ran on LOR

[~DOC~]

I have a pixcon 16 I bought off someone used I was intending to learn how to use E131. Short story I never got around too it. My question is do you still follow the same set up as mentioned in the manual to basically make this a pixie 16? Or do I set up in HU? The manual does not go into setting up in LOR too much. 

[Don]

Can't use the HU. 


Page 14:
The 2 RJ45 jacks labeled J3 and J4 can be used as an E1.31 to DMX bridge, or as
input/output from a standard LOR RS485 network depending on configuration. On
V1.3 and later boards these jacks are labeled as ‘DMX1 IN/OUT’

Whenever LOR equipment is in use on any of these RJ45 jacks, the jumpers must
be moved from the ESTA side to the LOR side.

Page 19:
To use the board with an LOR network rather than in E1.31 mode, select the
‘LOR’ checkbox. Selecting this box will allow the board to be connected to a LOR
network and be controlled like all other LOR controllers. Each pixel port on the
board should be given a unique Unit ID to avoid confusion.
Please note that while you can run the board in LOR mode, even when connected
properly it will not appear in the Hardware Utility if you search for controllers. 

Link to manual (for those who need it.)