minellix Posted November 4, 2022 Share Posted November 4, 2022 Have a uMP3g3 Gen3 mini Director that was used in past to run my show. Working on set up for controlling a Pixie16 and Pixie8. Plug Cat5 cable from Pixie16 into the Mini Director. My memory says it should power the mini director. However no power. Check the manual and it says it should power. Plug in external power and it works. Any idea where I am going wrong with the Cat5 cable powering the mjini director? I am wanting a setup that will us the two AC plugs powering the Pixie16 and Pixie8 and no more power cables. Have a preshow sequence and show sequence. The mini director would also need a switch to tell it when to change from preshow to show Link to comment Share on other sites More sharing options...
Jimehc Posted November 4, 2022 Share Posted November 4, 2022 Put a Jumper on JP2 header - right below Network Ports on the board Link to comment Share on other sites More sharing options...
TheDucks Posted November 4, 2022 Share Posted November 4, 2022 Gen 2 Pikies have a power jumper that needs to be in place JP2 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now