cmb24d

[Vince4xmas]

I have a CMB24D controlling (8) 10w LOR floods. I have (10) 50w LOR floods that are daisy chained to the same network as the CMB24D. Can I run the CMB24D in standalone mode and it will also control the other (10) 50w floods?

 

[Mr. P]

13 minutes ago, Vince4xmas said:

I have a CMB24D controlling (8) 10w LOR floods. I have (10) 50w LOR floods that are daisy chained to the same network as the CMB24D. Can I run the CMB24D in standalone mode and it will also control the other (10) 50w floods?

 

You shouldn't have any issues. Stand Alone can handle up to 10,000 commands but it doesn't have a limit listed for the number of controllers. I have a CMB24 that runs in Stand Alone with six other controllers and I don't have any issues.

[Vince4xmas]

Thanks for info Mr.P

[Mr. P]

35 minutes ago, Vince4xmas said:

Thanks for info Mr.P

Also keep in mind that the CF50 floods can run in Stand Alone also so if you have issues you can always install a simple sequence in them as well.

[Vince4xmas]

But I want all these RGB floods to run the identical sequence at the same time.

If I put the same stand alone sequence in each they will coordinate? Dont think they will.

OK with running all from CMB24D as master.

[TheDucks]

1 hour ago, Vince4xmas said:

But I want all these RGB floods to run the identical sequence at the same time.

If I put the same stand alone sequence in each they will coordinate? Dont think they will.

OK with running all from CMB24D as master.

You might want to use the 50 as the master.

You won't break anything by trying. Note standalone mode requires the network be Regular

[Vince4xmas]

TheDucks...thanks, that is what I plan to do. Thanks for tip that network MUST be reg.