Jump to content

Controller found, not able to run lights on unit


mlindell
 Share

Recommended Posts

mlindell wrote:

I have three controllers. I can run test on first two but not on thrid. It shows that it finds all three, just unable to get the lights to work on number three. Tried a reboot, and replug but nothing. Ideas?

If you can find all three controllers via the Hardware Utility, then I would verify that you have correctly set up your channels in your sequence.

From your description, it sounds as if you didn't set the channels correctly.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...