mlindell Posted November 23, 2008 Share Posted November 23, 2008 I'm setting up my display and the first 3 units are found no problem. I ordered two more units this summer. I connect direct to unit and can not find them. I get the blinking light, but that sall. Have unit search set at 15 units. I tried to unpluging and restart, Tried removing J10 jumper and then restarting and then replace jumper and restart. Any ideas on next step I should try? Link to comment Share on other sites More sharing options...
George Simmons Posted November 23, 2008 Share Posted November 23, 2008 Have you assigned each of the new units an ID number different than the first three? Link to comment Share on other sites More sharing options...
mlindell Posted November 23, 2008 Author Share Posted November 23, 2008 That my problem I can't find uits so that I can assign an ID. Link to comment Share on other sites More sharing options...
George Simmons Posted November 23, 2008 Share Posted November 23, 2008 Run the LOR hardware utility. On the left side of the screen, half-way down, you can set the unit ID. Then your search should find it. Link to comment Share on other sites More sharing options...
mlindell Posted November 23, 2008 Author Share Posted November 23, 2008 Well I did what you said and nothing. I saw my computer was doing a virus scan and found a not responding in task manager. Restarted again and disables virus scan and yes we are assigning ID's thanks everyone for your help. I guess always reboot and restart program 3,4,5 times and maybe you'll get lucky. Thanks everyone. Link to comment Share on other sites More sharing options...
taybrynn Posted November 23, 2008 Share Posted November 23, 2008 Unplug the LOR interface USB cable and plug it back in to a different USB port. Link to comment Share on other sites More sharing options...
Recommended Posts