Erik Posted November 22, 2008 Share Posted November 22, 2008 I ran into a major problem today. This morning all controllers were working and i was able to assign ID's to all them this morning. We completed the putting the lights up and running extension cords and cat5 . When I went to test tonight I wasn't getting all of the controller's in the hardware utility, upon investigation I discovered that the led on 1 one of the controllers was not on. I tried replacing the fuses with no luck and I noticed that the label on the heat sink appears to have melted some.I have emailed LOR but that I would see if anyone here had any suggestions? Link to comment Share on other sites More sharing options...
cmoore60 Posted November 22, 2008 Share Posted November 22, 2008 Do you know that you have power up to the terminal block on the controller?The fuse on the right is what provides power to the electronics on the board in addition to the power for channels 9-16.Chuck Link to comment Share on other sites More sharing options...
Erik Posted November 22, 2008 Author Share Posted November 22, 2008 cmoore60 wrote: Do you know that you have power up to the terminal block on the controller?The fuse on the right is what provides power to the electronics on the board in addition to the power for channels 9-16.ChuckI don't know. All I know is no LED and no power to lights. Could you tell me how I could test to see if there is power getting to the board? Link to comment Share on other sites More sharing options...
cmoore60 Posted November 22, 2008 Share Posted November 22, 2008 If you have a meter, you can check on the terminals for the input power on the right side of the board. The right side (channels 9-16) also power the electronics on the board. Link to comment Share on other sites More sharing options...
Recommended Posts