cbelt4 Posted December 10, 2021 Share Posted December 10, 2021 This year I added the 10w floods. I got the a little to late in the year to try and incorporate them into a show. Just playing with them today and My floods come on with my pixel tree. I did change its box ID to 6 my pixel trees ID is 5. I have read as much as I can today through out the forums and haven't found anything remotely close to this issue. No I have not made a prop preview for them. All in all they shouldn't even come on unless I put them in as a prop. Link to comment Share on other sites More sharing options...
TheDucks Posted December 10, 2021 Share Posted December 10, 2021 Pixie controllers use 1 port per PORT eg Pixie8: 05,06,07,08,09,0A,0B,0C Link to comment Share on other sites More sharing options...
cbelt4 Posted December 10, 2021 Author Share Posted December 10, 2021 (edited) Ok I was wrong on my RGB floods they are unit 8 Pixie is unit 5. so why would they both come on at the same time when I dont have my floods in any om my sequences. Edited December 10, 2021 by cbelt4 mistake Link to comment Share on other sites More sharing options...
k6ccc Posted December 10, 2021 Share Posted December 10, 2021 You did not say which Pixie you have, but as TheDucks said, each port on the Pixie uses one Unit ID. So if your Pixie is at least a Pixie 4, with an assigned Unit ID of 05, it will use 05, 06, 07, & 08 (and more if Pixie 8 or Pixie 16. So the fourth port of the Pixie is the same Unit ID as the RGB controller for the floods. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now