DRAD13 Posted December 5, 2021 Share Posted December 5, 2021 Can anyone tell me what changes need to be made on the controller to run E1.31 on this board and which port the ethernet cable would plug into to run show software. i have changed the 3 jumpers from lor to esta. I usually plug into the top black port to run lor. do is use same port or the silver ethernet port? Thanks. Link to comment Share on other sites More sharing options...
k6ccc Posted December 5, 2021 Share Posted December 5, 2021 For Ethernet, use the silver connector. For E1.31, the jumpers you mentioned make no difference at all. On the other end of the cable, you plug into a computer LAN port - NOT a LOR USB network adapter. Link to comment Share on other sites More sharing options...
DRAD13 Posted December 5, 2021 Author Share Posted December 5, 2021 thanks, i can't seem to get it to communicate so i didn't know if i needed to make any adjustments to the board. Link to comment Share on other sites More sharing options...
k6ccc Posted December 5, 2021 Share Posted December 5, 2021 All config for a Pixcon 16 is done via an Ethernet connection from Network Preferences - not the Hardware Utility. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now