Pixcon 16

[dan24438]

So i'm having some weird issues with my two pixcon 16. When i only connect one of the pixcon to my router the individual pixcon shows up and i can run all pixels no issues. When i plug both pixcons into the router my older mk1 pixcon will randomly drop off/on the network. I'm not sure what i've done wrong or if maybe i have a bad controller? Below is all of my information. Any suggestions would be very helpful. 

 

MKII: IP: 192.168.2.3 set to Dynamic (i have tried setting it to static to see if this is the issue and it doesn't not fix the problem), Firmware: 2.0.13

MK1: IP: 192.168.2.2 set to static, firmware: 1.4.8

My version is 5.5.14 Pro

 

Again any suggestions are welcome. Thanks in advance. 

[k6ccc]

From your computer, can you ping 192.168.2.2?

 

[dan24438]

yup sure can. So when both controllers are plugged in I can ping both, but only the new Mk2 board will show up in the network pref

[k6ccc]

I would not get overly worried about that.  Can it play in a sequence?

Same concept as LOR devices not showing up in the HU...

 

[dan24438]

You were absolutely right. Still can't get them both to show up in the utility but running a sequence they both worked flawlessly. Thank you very much. I spent the better part of 3 hours trying to trouble shoot these things and all the while they were working just fine. Thanks again.