Azzo Posted November 22, 2020 Share Posted November 22, 2020 I have 12 controllers connected together. It 11 outbof the 12. The controller in questions has power. I reset the controller. It went thru the reset process ok. The controller is in the middle of the controllers it sees the controller before and after it. I am thinking of pulling it out and re setting the controller by itself. Thru HU. Any thoughts. Link to comment Share on other sites More sharing options...
PhilMassey Posted November 22, 2020 Share Posted November 22, 2020 Does it play from a sequence. The HU often misses a controller in the scan, If it plays, don't worry about it. If it is not actually connected, blinking, then your plan is sound. Puli it out and test it by itself. Link to comment Share on other sites More sharing options...
Azzo Posted November 22, 2020 Author Share Posted November 22, 2020 It is blinking Link to comment Share on other sites More sharing options...
TheDucks Posted November 22, 2020 Share Posted November 22, 2020 49 minutes ago, Azzo said: It is blinking Your network driver chip may be bad. (the LOR jacks, just pass thru the signals, so the connectorS seems to be good) Do pull the unit inside and do the Reset (I have a couple of RJ45 couplers, I keep so I can use the rest without re-cabling in the mean time ) Link to comment Share on other sites More sharing options...
Azzo Posted November 23, 2020 Author Share Posted November 23, 2020 I resolved the issue brought control in. Had to update the firmware on the unit. Thank you for all the help. Link to comment Share on other sites More sharing options...
Recommended Posts