ELL, 4 ch. controller with ELL

[mrforemark]

 

• 
• Members
•  692
• 3,761 posts
• Location Ga.
• LOR Software Version:4.3.24
• License Level:Pro

•  

Posted 16 hours ago (edited)

In the HU under the LOR RF tab where you configure the ELL side of the controller there is a power level setting you can change. Also make sure that you set up the receiving CTB04-ELL on the same frequency and network speed. They should be set at the same speed that you are running your network up to 115K.

Also keep in mind that these are line of sight.

Edited 16 hours ago by Mr. P

•  
• Quote

 

Keep It Simple Stupid

"Life is hard, it's even harder if you're stupid." - John Wayne

mrforemark

• Member
•  
• Members
•  0
• 96 posts
• Location ohio
• LOR Software Version:5.3.10
• License Level:Advanced

• Author

•  

Posted 15 hours ago

Will the CTBO4-ELL need to be hard wired to the adapter to facilitate this change, or can it be done via RF

 

•  
• Quote

Mr. P

• Member
•  
• 
• Members
•  692
• 3,761 posts
• Location Ga.
• LOR Software Version:4.3.24
• License Level:Pro

•  

Posted 14 hours ago

Each one should be hardwired one at a time for configuring and they should each be the only controller connected.

•  
• Quote

 

Keep It Simple Stupid

"Life is hard, it's even harder if you're stupid." - John Wayne

mrforemark

• Member
•  
• Members
•  0
• 96 posts
• Location ohio
• LOR Software Version:5.3.10
• License Level:Advanced

• Author

•  

Posted 11 minutes ago

Thanks Mr. P.   Do similar procedures need to be performed to the ELL's in the system?  Still not talking across the street.  

 

•  
• Quote

mrforemark

• Member
•  
• Members
•  0
• 97 posts
• Location ohio
• LOR Software Version:5.3.10
• License Level:Advanced

• Author

•  

Posted just now

Additionally, can you suggest settings that would best serve my predicament?  I found the ELL user manual and see that changes can be made.  I also see that coinciding changes will need to be made in sequence editor/show player.  I'm an old dude with little knowledge in this field and appreciate your patience.  I hope you get paid nicely for this baby sitting, LOL...