Jump to content

Stand alone problem


Kevin N
 Share

Recommended Posts

I've got an odd problem. I'm trying to run a simple 3 minute stand alone sequence for Halloween (6 channels, but only 3 are really active) and it runs fine in the sequence editor...but runs at triple speed once loaded into the controller. Needless to say...this isn't going to be what I need. Any suggestions on what might be wrong? I don't want to have to leave the PC hooked up for this simple display. Please help!!!

By the way...the sequence shows 9212 bytes when loading onto the controller...if this helps.

Thanks in advance.


Also, I've tried a "hard" reset on the unit to no avail.

Link to comment
Share on other sites

LightORamaJohn

Is the little stand alone speed control pot near the phone in jack centered?

Link to comment
Share on other sites

It is now ;). I feel a bit stupid right about now. I forgot all about that pot (this is my first time doing stand alone). Thanks you so very much for your help, John. Once again...this is why Light-O-Rama is number 1 in customer service! You guys (and gals) are great. Again, thanks.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

×
×
  • Create New...