Valentin Posted August 29, 2019 Posted August 29, 2019 (edited) Hi! I want to set up my pixcon16 unit. The unit is connected to the computer, i can see it in network configuration program, i can open the device and check different boxes and change settings. But when i press OK (or APPLY then OK) and then enter again in the device, there is no any changes. What i'm doying wrong? what i need to check? I have 5 or six brand new pixcon16 MkII V1.0 (V2.0.17), and i have the same situation with every piece. I have triple checked different settings, tuned up the firewall settings, ip address, etc. Edited August 29, 2019 by Valentin
Valentin Posted August 30, 2019 Author Posted August 30, 2019 (edited) Yersterday I tried to save config to my pixcons, but without any success. And after I analised network communication between my PC and pixcon16, i noticed some packages contained "Advatech". I downloaded and installed "advatech assistant" and succesfully changed and saved settings. And i have no idea, why i can't do it in "LOR network configuration". Edited August 30, 2019 by Valentin mistakes
Recommended Posts