cenote Posted July 30, 2008 Share Posted July 30, 2008 Using firmware ver 4.02. Built another board tonight, and problems went as following.Assigned board # - No problemSwitched all on, none came on. LED Light still solid.Unplugged unit, reboot hardware, and turned all channels on, all came on, now all channels won't turn off.Unplugged again, reboot board, and now only channels 9-16 work perfect, but 1-8 no response.Rebooted twice, and tried flashing board, still same problem with 1-8.Any ideas where to start looking?Thanks in advance,Chuck Link to comment Share on other sites More sharing options...
Guest wbottomley Posted July 30, 2008 Share Posted July 30, 2008 Try flashing your firmware. Link to comment Share on other sites More sharing options...
Dr. Jones Posted July 30, 2008 Share Posted July 30, 2008 ChuckI have had similar problems. In the past I have sent the board back to LOR for repair. I found out an IC chip had failed.note to self ( you still need to send that bad board in for repair) Link to comment Share on other sites More sharing options...
cenote Posted July 31, 2008 Author Share Posted July 31, 2008 Thanks for the suggestions. Thought it might be a IC problem...Sure enough after looking over board three times, found the one pin on large IC not soldered. Works fine now.(note to self...NO BEER after soldering resisters) Link to comment Share on other sites More sharing options...
Recommended Posts