tbuff23 Posted February 19, 2018 Share Posted February 19, 2018 I purchased a CCBII pulled it out of the box I tried set it up but no luck. The red light flashes then turns solid So I know it is seen by the computer. I set up the RGB channels in SE it will only let me do 512. I have CCB II with 200 lights which = 600 channels. The Hardware utility will not even recognize the controller Do I need to set up 2 channels one for each string? Thanks in advance!!!! Link to comment Share on other sites More sharing options...
tbuff23 Posted February 19, 2018 Author Share Posted February 19, 2018 Ok I set the max ID to FO and I found the controller I can test the lights in hardware utility but not in SE. Link to comment Share on other sites More sharing options...
dibblejr Posted February 20, 2018 Share Posted February 20, 2018 (edited) Your channel configuration is boogered up. Also what version of software? Disregard my controller question. JR Edited February 20, 2018 by dibblejr Link to comment Share on other sites More sharing options...
dibblejr Posted February 20, 2018 Share Posted February 20, 2018 Also comm port needs to be set correctly, could be either or, or both boogered. JR Link to comment Share on other sites More sharing options...
tbuff23 Posted February 20, 2018 Author Share Posted February 20, 2018 3.24 PRO the comm port is good. The channels could be wrong I right clicked the last channel added new device and am starting over with the numbering It set it up as 2 controllers and gives me the 600 channels 300 per sting. Link to comment Share on other sites More sharing options...
dibblejr Posted February 20, 2018 Share Posted February 20, 2018 What controller? Link to comment Share on other sites More sharing options...
tbuff23 Posted February 21, 2018 Author Share Posted February 21, 2018 The controller is a CCBII 2 strings 100 bulbs each string Link to comment Share on other sites More sharing options...
dibblejr Posted February 21, 2018 Share Posted February 21, 2018 (edited) 1 hour ago, tbuff23 said: The controller is a CCBII 2 strings 100 bulbs each string That question must have been in my que from yesterday. How do you know the comm port is correct? I didn’t have any problems configuring my CCBs Also check your unit IDs to ensure you have not duplicated any JR Edited February 21, 2018 by dibblejr Link to comment Share on other sites More sharing options...
tbuff23 Posted February 21, 2018 Author Share Posted February 21, 2018 I set up another controller CCR IT WORKS FINE Link to comment Share on other sites More sharing options...
tbuff23 Posted February 21, 2018 Author Share Posted February 21, 2018 Ok the ID # was wrong I have 1/2 the string working. I need to change the unit ID mode but it is grayed out the manual is not much help does anyone know how to change it to dual normal CCB two unit ID's? Thanks for the help Link to comment Share on other sites More sharing options...
k6ccc Posted February 21, 2018 Share Posted February 21, 2018 All I can tell you is that with CCPs, you change the mode in the Hardware Utility. Link to comment Share on other sites More sharing options...
Recommended Posts