cam308 Posted December 11, 2017 Share Posted December 11, 2017 Anyone know why a Pixie8 controller would keep resetting the Unit ID back to 01? I have it set as Unit ID 33 on AUXA Network with a few other Pixie8 and a PixCon16, all of which are assigned different Unit ID's, none of which are 33. So each device has it's own unique ID. I'm pretty sure the affected Pixie8 loses it's assigned ID when I power cycle the controller. I'm not 100% on that, as I'm waiting to see if it goes without me power cycling. But either way, none of the other Pixie8 on that outlet lose their ID when I power cycle, so I think something is going on here. Any suggestions? Link to comment Share on other sites More sharing options...
cam308 Posted December 11, 2017 Author Share Posted December 11, 2017 Pretty sure I found the answer in another post from Mr. P. Appreciate the info. I quoted it below: On 12/3/2017 at 2:46 PM, Mr. P said: If you have the new pixie, the one with the dip switches on the board then you need to turn them all off or to zero then set the ID with the HU. The switches override the HU ID when the pixie is powered down. 1 Link to comment Share on other sites More sharing options...
Recommended Posts