pixcon 16

[movieman4]

hello,

i have for the first time a pixel controller.

i have bought a sequence from holidaycoro and changed the adresses.

it will not lit.

before i had 8 controllers so i set my pixcon on starting channel 09 up to 18

also the sequence is named from 09 till 18

i use elor mode so i set the jumpers to lor.

i tried 57,6k speed and 500k speed.

in testing mode the ccr ribbons will lit ok.

please help

[movieman4]

this is the channel config:

is this ok for elor network?

[movieman4]

o yes , both lights red and green on the board are steady.

[movieman4]

and in the sequence i bought there were 7 more channels in each ccr , do i need them?

[movieman4]

and i am running in regular network only , do i have to split into reg for normal controllers and aux for pixcon16?

[TheDucks]

3 hours ago, movieman4 said:

this is the channel config:

is this ok for elor network?

Uh

That is for DUMB RGB (4 wires)

[Mr. P]

2 minutes ago, TheDucks said:

Uh

That is for DUMB RGB (4 wires)

It's also for pixcon channels if used on the LOR network.

[TheDucks]

5 minutes ago, Mr. P said:

It's also for pixcon channels if used on the LOR network.

Ah.  I only have a Pixie

[movieman4]

ok , i have put my pixcon16 in a differend network (auxA) , and now it is working fine.

thanks!