Added rgb files to existing files

[Daniels Halloween house]

Hello I've run into a problem when adding rgb channels to my existing files that have lor a.c. units. I set the networks up, had n issue at first.  When i go to show builder. Add files, schedule show and  enable show it runs as error over n over again, it's running as a lms.lss at the end of the files which seems to keep showing error...  my question is am I saving the new sequence wrong or loading the show wrong ... everything worked fine before this change... I'm run actidongle thru one sub on comm3. And 485usb on comm 4... 

[Crimson Lane Lights Etown]

I was waiting for a positive update from you.  What software version are you running?  I run one LOR rs485 booster in one usb port (Com3) and one HC actidongle in another usb port (Com5).  I have software 4.3.24 Pro.    When I added rgb channels to my exsisting sequence, I right clicked and inserted channels above or below.  Then assigned the rgb channels to the dmx universe that had the actidongle displayed.  I didn't have to change any of my show files in editor/builder or show schedule editor. 

[k6ccc]

On 11/27/2017 at 7:20 AM, Daniels Halloween house said:

When i go to show builder. Add files, schedule show and  enable show it runs as error over n over again, it's running as a lms.lss at the end of the files which seems to keep showing error...  my question is am I saving the new sequence wrong or loading the show wrong ..

Please give us a step by step of what you are doing.  Unless you are doing something strange, it's unlikely you would end up with a lms.lss filename.  You clearly have a bunch of steps you have not told us since building your show does not really relate to adding channels to sequences.