ukoberon Posted November 26, 2017 Share Posted November 26, 2017 (edited) After a successful first year last year with no issues, im having problems with a pixie 16 controller leaving artifacts on my 12 ribbon tree. Any thoughts and suggestions appreciated. My setup has 2 circuits - standard circuit running all other elements (including the LOR wifi link to a remote box) and the separate Aux network running at high speed with 2 x twinned pixie 16 controllers each running 12 ribbons and 3 separate 50wFloods. The two pixie controllers share the same address so the content appears on both - but my issue is that the first in the circuit keeps leaving random pixels and colors turned on during the sequences which then clear after the sequence moves on to the next element- sometimes a set of 3 sometimes 6 or 9 - on any one of the 12 ribbons that make up the tree. The 2nd controller in the circuit doesnt display this behavior and runs without issue. so far i have: separated the circuit fully from any other components resaved the sequences into new location Tried compressed and uncompressed files Any suggestions as to what else i could try here? Many thanks Rob Edited November 26, 2017 by ukoberon replaced word Link to comment Share on other sites More sharing options...
ukoberon Posted November 27, 2017 Author Share Posted November 27, 2017 DUPLICATED POST IN WRONG SECTION - Moderator please delete. Thank you . Link to comment Share on other sites More sharing options...
Recommended Posts