racerc20 Posted October 8, 2017 Share Posted October 8, 2017 I want to add some dumb rgb strips to my cmb24d rgb board. Does anyone know the correct pin out on the dongles on the board. Or do i have to break out the multimeter. Lol. If i am holding the connector with the guide pin or slot at 12 oclock what wire goes where. TIA. Carl Link to comment Share on other sites More sharing options...
PhilMassey Posted October 8, 2017 Share Posted October 8, 2017 Break out that multimeter. Wire colours and pin outs vary by manufacturer, and even production run. Link to comment Share on other sites More sharing options...
racerc20 Posted October 8, 2017 Author Share Posted October 8, 2017 Thanks Link to comment Share on other sites More sharing options...
JSteinwall Posted October 9, 2017 Share Posted October 9, 2017 This is what I determined back in 2014. I am not sure if they are shipping the same dongles. Link to comment Share on other sites More sharing options...
Vince4xmas Posted October 9, 2017 Share Posted October 9, 2017 Use a meter as I have also had different colored wires as well as several wires going to the wrong pins. Link to comment Share on other sites More sharing options...
Recommended Posts