Jump to content
Light-O-Rama Forums

Recommended Posts

Posted (edited)

I have a Gen3 controller which has 20 pin header. For a trigger, my manual says to use the gnd and input 1, wired to a normally open switch which I have done.  This would be the  two left most pins of the bottom row of the header, facing the controller with the header at the top.   Looking at the picture and data sheet of the CTB-Input-G3 board on LOR website It appears that there is a couple of screws +5 and +9 seperating the gnd and input 1. Does anyone have a schematic or diagram of this board?

I am getting false triggers and first of all want to make sure I am wired right.  I

 

thanks

Edited by butlerlj
  • The topic was locked
Guest
This topic is now closed to further replies.
×
×
  • Create New...