Powers_Ronald Posted November 22, 2016 Share Posted November 22, 2016 I bought two Pixcon16 this last year. I have one up and running, but the second one seems dead to the world. It has power, but the Green Power LED is off, while the Red Status LED is solid on. I attempted entering bootloader mode (both LED flashing) but the unit does not show in the PixCon devices on network configuration (ver 4.3.8). Even after placing the the Pixconn16 directly to a laptop, nothing. I have no issues with the first unit, it shows up on the list and seems to be working fine. It is just this second unit I can not get working. Link to comment Share on other sites More sharing options...
Powers_Ronald Posted November 22, 2016 Author Share Posted November 22, 2016 (edited) Got the unit back up and running. I needed to put a fix IP address on the laptop (192.168.0.X) before it would find the bootloader (192.168.0.50). After that I was able to see the unit. However, it would not accept the firmware for network configuration (it never rebooted) but it did take the ver 1.4.8 hex file when using LORPixCon16Assistant. Everything seems to be working now. Edited November 22, 2016 by Powers_Ronald Link to comment Share on other sites More sharing options...
melody Posted November 26, 2016 Share Posted November 26, 2016 I'm having this issue I can't even download the firmware okay so on the page there are 2 assistants which one did you use the one had the download link removed Link to comment Share on other sites More sharing options...
Recommended Posts