katfish Posted September 22, 2016 Posted September 22, 2016 having trouble running the pixel editor sequence in sequence editor. I created a sequence in sequence editor then opened it in pixel editor, then saved the sequence then the intensity data. Opened the sequence in sequence editor and it showed it was there but running through the sequence the lights did not work (I have them set up for samples). any ideas as to what I am doing wrong. I have done regular lights to light o rama for the past 8 years but this is the first time with cosmic color pixels.
Dennis Laff Posted September 22, 2016 Posted September 22, 2016 What controllers are you using in the pixel editor ,if they are lor controllers the need to be set to enhanced mode in network Preferances 1
katfish Posted September 23, 2016 Author Posted September 23, 2016 Will enhanced mode allow me to run my other LOR controllers along with the CCB's?
Mr. P Posted September 23, 2016 Posted September 23, 2016 7 minutes ago, katfish said: Will enhanced mode allow me to run my other LOR controllers along with the CCB's? Depends on how old your controllers are and what version. You can check here: http://www1.lightorama.com/network-speeds/
Brucey Posted September 23, 2016 Posted September 23, 2016 Also, be careful of how much you're putting on one network so you don't introduce lag or poor show performance
SPaschall Posted September 23, 2016 Posted September 23, 2016 1 hour ago, katfish said: Will enhanced mode allow me to run my other LOR controllers along with the CCB's? Gen 3 controllers can use the enhanced network,If you have older controllers along with the Gen3 then you will need two dongles and two separate networks running from the computer. SPaschall
Recommended Posts