Using LOR CCB in Pixel Editor

[christmascrossing]

I'm using an LOR CCB with 2 strings of 50 pixels.  I defined the prop as 2 spokes with the first pixel in the middle.

Which effect can I use to move a bar of pixels from left to right (across the entire 100 pixels)?

Maybe I don't have the prop defined correctly??!? 

Basically I want to treat the two CCB strings as one long 100 pixel  line.

Any suggestions please?

 

[MattBrown]

To set up the CCB as a single string of 100, using the following presentation as a guide - starting on page 23:

http://www1.lightorama.com/PDF/PE_Previews_2016.pdf

On the PE prop definition page, set the number of strings to 1 and the number of pixels to 100. That should do it. Make sure Max Circuit is set to 150. The carryover column will show 150 (this is the number of circuits that will be assigned to the next unit id).

Matt

 

[christmascrossing]

Thank you Matt.