Bevvyboy Posted August 21, 2016 Posted August 21, 2016 Hi Guys I am a newby that has just built the 16 channel DIY kit, I have plugged it in (mains) switched on and no Setup Light came on, I have power at the hot and neutral contacts, Full Voltage, both ends of the fuses were also tested to neutral Hopefully one of you good guys will have some ideas as to why it doesn't want to power up? and because of this the port on the computer cannot find a consul to assign Help Urgently required please
Dennis Laff Posted August 22, 2016 Posted August 22, 2016 did you install the drivers for the usb 485
LOR Staff Posted August 22, 2016 Posted August 22, 2016 You DID properly set the jumpers for 240V operation, before plugging it in, correct? If your completed kit build is not working as you had hoped, here's the first place to start troubleshooting:http://www1.lightorama.com/PDF/Kit_Troubleshooting_Guide.pdf
Bevvyboy Posted August 23, 2016 Author Posted August 23, 2016 Dennis Laff and DevMike Thanks for your help I checked out the hyperlink and worked through it only to find that, the Transformer is supplied by the group 9 - 16 and I had only put power on 1 - 8 Now sorted and up and running Thanks again
Recommended Posts