Maine Lights Posted April 9, 2016 Share Posted April 9, 2016 What does everyone recommend for the power supply for the LOR servo dog controller? Link to comment Share on other sites More sharing options...
Ebuechner Posted April 10, 2016 Share Posted April 10, 2016 That is a loaded question my friend that would all depend on what you plan on hooking up to that board. All I'm using is an old Netgear power supply from a dead router. The output on that power supply is 12 volts with 5 amps. Link to comment Share on other sites More sharing options...
Orion Posted April 10, 2016 Share Posted April 10, 2016 I am running a 12 volt to run the servo dog. And (2) 6 volts to run the servos. I have found it better to leave he servo dog on but disable power to the servos when not in use. Link to comment Share on other sites More sharing options...
building2 Posted April 11, 2016 Share Posted April 11, 2016 I use an old 12 VDC battery charger that has a provision for a jump start. It works great with plenty of ampacity. Link to comment Share on other sites More sharing options...
Recommended Posts