StuartA Posted December 11, 2015 Share Posted December 11, 2015 In the attaced animation sequence, Circuit 1 is programmed to come on and stay on. Circuit 2 is programmed to come on and stay on 4/10 seconds later. And so on through Circuit 13. Problem is the Circuit 1 does not come on.The circuits are programmed to immediately do the sequence in reverse - starting with 13. In that case Circuit 1 does come on at the end.Any suggestions? Using Sequence Editor v3.10.12Controller CTB16PCMiniDirectorLOR 2 Tree Lights 2015 v2.las Link to comment Share on other sites More sharing options...
mark obermiller Posted December 11, 2015 Share Posted December 11, 2015 You have new channels at the bottom configured to the same controller. Remove or change your controller number to anything but 2 in the channel configuration on these new channels. If this doesn't work, check and see if channel 1 will turn on using the Hardware editor. If it does not then it's most likely a bad triac. Link to comment Share on other sites More sharing options...
Recommended Posts