disneythunder Posted December 7, 2015 Share Posted December 7, 2015 I have been trying to get my pixcon 16 up and running and I've gotten most of the kinks worked out. However, I'm still having some trouble. I finally got communications and both of the status lights are finally solid on my board running the latest firmware. I tried doing a test animation sequence and the lights didn't respond and were stuck on solid white. I went and did the hardware test by holding the factory IP button for 3 seconds and the lights didn't change. I checked the pixel schematics and it looks like I do have the data input side wired correctly. Any suggestions?Thanks! Link to comment Share on other sites More sharing options...
zenitramtech Posted December 7, 2015 Share Posted December 7, 2015 This happened to me when I set up the PixCon16 Assistant and didn't select the fast checkbox for the LED's. Also, be sure that you selected the correct chip type. Hope it helps. Link to comment Share on other sites More sharing options...
disneythunder Posted December 8, 2015 Author Share Posted December 8, 2015 Thanks. Just needed to check the high speed box. Everything's working great now! Thanks again! Link to comment Share on other sites More sharing options...
Recommended Posts