Wayne K Posted November 23, 2015 Share Posted November 23, 2015 I just fired up my display to test it and it acts like I have a bad controller. When I run an all on sequence several channels on this controller seam to be either in shimmer and / or twinkle mode. but yet when I go to the hardware utility and run them 1 channel at a time all seems fine. This is a all on sequence that I used last year with no problems. The only difference is that I updated the lor software suite a week or so ago on my show computer.In the hardware utility it shows the device as 06-CTB16D VER 4.?SInce it shows a question mark, is it possible that the firmware is corrupt? Wayne Link to comment Share on other sites More sharing options...
Wayne K Posted November 23, 2015 Author Share Posted November 23, 2015 I now have it working and showing up properly in hardware utility. I found 1 of my ethernet plugs not quite all the way in. Pulled the plug and re seated it and all works fine now. Still don't know how / or why I was able to make all of the channels work in the hardware utility 1 at a time Wayne Link to comment Share on other sites More sharing options...
Recommended Posts