Jump to content
Light-O-Rama Forums

cant get G3 director to control pixcon


Recommended Posts

I am hoping someone can lend me a hand with some setup information. I am trying to get a new g3 director to run a pixcon controller. I have a xlight imported sequence in the sequence editor that I can get to run just fine in SE. I do have the LOR Pro. When I plug my usb485 into the pixcon the status light goes solid and the sequence can play. I know the pixcon and sequence are setup correctly. My issue comes when I try to use the director. I saved the file and loaded it to the SD card and fire up the director, but the status light never goes solid and no sequence plays.

Is there a document that tells you step by step what is required to get the two units to talk to each other. I am sure it's just a setting or step I'm missing somewhere.


Link to comment
Share on other sites

  • The topic was locked
This topic is now closed to further replies.
  • Create New...