toddm1919 Posted November 21, 2015 Share Posted November 21, 2015 It' s been running for over an hour and a half. When I would run it last year, it would be done in about 10 minutes. I did add a bunch of RGB dumb strips and 9 CCPs this year, so I was expecting it to take a longer amount of time, but I wasn't expecting it to take this long. I have also noticed on several occasions that the percentage reported would be above 100%. I it is progressing, so I will let it go. I was just wonder if this amount of time is normal.Thanks,Todd Link to comment Share on other sites More sharing options...
toddm1919 Posted November 21, 2015 Author Share Posted November 21, 2015 Almost 3 hours and still running...is this normal? Link to comment Share on other sites More sharing options...
Slowpoke Posted November 21, 2015 Share Posted November 21, 2015 Is this verifier something you run from hardware utility ? Link to comment Share on other sites More sharing options...
PhilMassey Posted November 21, 2015 Share Posted November 21, 2015 Not in my experience. Usually takes a few minutes. I would stop it and reboot and try again. Link to comment Share on other sites More sharing options...
toddm1919 Posted November 21, 2015 Author Share Posted November 21, 2015 It is in the control panel. Link to comment Share on other sites More sharing options...
toddm1919 Posted November 21, 2015 Author Share Posted November 21, 2015 Already rebooted. I started it last night, then after about a half hour, I canceled it and turned off the computer. This morning I booted it up and started the verifier again. Link to comment Share on other sites More sharing options...
PhilMassey Posted November 21, 2015 Share Posted November 21, 2015 What version of LOR are you on. Might what to consider uninstalling and re-installing, Data SHOULD be OK but BACKUP first.I'm on 4.2.10 and the verify just took all of 5 seconds. Link to comment Share on other sites More sharing options...
toddm1919 Posted November 21, 2015 Author Share Posted November 21, 2015 I'm on 3.12.0. Wanted to make through this year before upgrading to S4. Link to comment Share on other sites More sharing options...
George Simmons Posted November 22, 2015 Share Posted November 22, 2015 (edited) What exactly are you verifying? A sequence, a show, or the entire schedule? / Edited November 22, 2015 by George Simmons Link to comment Share on other sites More sharing options...
toddm1919 Posted November 22, 2015 Author Share Posted November 22, 2015 An entire show. It finally finished after 10 hours. Thankfully there were only warnings..no errors. Link to comment Share on other sites More sharing options...
Recommended Posts