Gr8jeepin Posted November 20, 2015 Share Posted November 20, 2015 I am at work.. but working on my display. Does anybody know the diameter of the Cosmic Color pixels? I am messing around with a possible sign and am trying to figure out what diameter to make the holes for the pixels. Thanks in advance! Link to comment Share on other sites More sharing options...
k6ccc Posted November 20, 2015 Share Posted November 20, 2015 Take a look at my website below, then click on the link for the arches. This will give you a good idea what I am doing similar. As I recall I used a hole just slightly smaller than 1/2 inch. Might have been 31/64 but I would have to look and I'm also at work. Link to comment Share on other sites More sharing options...
wmilkie Posted November 20, 2015 Share Posted November 20, 2015 12mm pretty sure which is about 1/2" Link to comment Share on other sites More sharing options...
George Simmons Posted November 21, 2015 Share Posted November 21, 2015 I use a 1/2" bit when drilling them into PEX. Works just fine unless you have a bit of extra epoxy on the pixel. Link to comment Share on other sites More sharing options...
Psjoe Posted November 21, 2015 Share Posted November 21, 2015 On my matrix I used 1/2" bit. Just lets the bulb through so was perfect.I did 2" spacing between bulbs after reading a lot of forums. Works good. Link to comment Share on other sites More sharing options...
Recommended Posts