Problems with CCR's

[Ericcova]

Hi,

 

Having an issue getting my CCR's to work in Pixel Editor. I tried sequences that I had done using the SE, and those work. The sequences I did in PE only light up the first few pixels, and they don't seem to be doing what they are supposed to. I tried a few different ways of setting up the props, here is what it is set to now. Only using the PE to do the sequence, although the arches are physically listed in the SE. That doesn't seem to bother the RGB ribbons or pixel tree though.

 

2 CCR's for 4 arches

 

Set as RGB/Arch/1 section/25 nodes (half arch)/LOR/Regular network/0A unit/start 1 end 75

Set as RGB/Arch/1 section/25 nodes (half arch)/LOR/Regular network/0A unit/start 76 end 150

 

Any help would be appreciated.

 

Thanks,

Eric

[Ericcova]

Nevermind, enabled enhanced protocol in network preferences. Hopefully it doesn't mess with the other controllers.

[MattBrown]

Nevermind, enabled enhanced protocol in network preferences. Hopefully it doesn't mess with the other controllers.

 

Glad you figured it out. When you mark a network as "enhanced" in Network Preferences, all controllers on that network need to understand the enhanced LOR protocol and thus need the latest firmware.

 

Matt