msteiner57 Posted October 3, 2015 Share Posted October 3, 2015 In an earlier post I followed DevMike's suggestion in finding my controller in the HU. It shows up as controller #80. I reset it to #3 as that is what I wanted it to be. It works just fine directly from the show computer by itself. When I set it up outside in tandem with 2 other controllers (CTB16pc's) it wont work. I found out that the unit ID changes back to 80. I quit arguing with the darn thing and re configured my channels in the sequences for that unit ID. All is ok now but why would jumping from my other units make it change the Unit ID #. My ID switches on the controller are 1 and 2 on with all others off. Thanks for any input Link to comment Share on other sites More sharing options...
Mr. P Posted October 3, 2015 Share Posted October 3, 2015 The CMB24D ID is not set with the HU it is set by the dip switches on the card. Link to comment Share on other sites More sharing options...
Mr. P Posted October 3, 2015 Share Posted October 3, 2015 (edited) To set a CMB24D as controller #3 you have to turn #8 and #9 dip switches on and leave the rest of them off. Dip switches 1 and 2 on give it a ID of 384 and LOR doesn't go that high on the chart. Edited October 3, 2015 by Mr. P Link to comment Share on other sites More sharing options...
msteiner57 Posted October 3, 2015 Author Share Posted October 3, 2015 Thanks for the info Mr. P. Wih the dip switches I was going by what the manual said Link to comment Share on other sites More sharing options...
Mr. P Posted October 3, 2015 Share Posted October 3, 2015 (edited) The manual on the website is correct if you download that one. The charts start on Page 20. http://www1.lightorama.com/Documents/CMB24D_Man_Web.pdf Edited October 3, 2015 by Mr. P Link to comment Share on other sites More sharing options...
msteiner57 Posted October 3, 2015 Author Share Posted October 3, 2015 That's what my problem was, I started on the wrong side of the switches, Thanks again Link to comment Share on other sites More sharing options...
jstorms Posted October 3, 2015 Share Posted October 3, 2015 Link to comment Share on other sites More sharing options...
Recommended Posts