network config error

[santa25]

Hi, I am getting an error message when I click on network config, screen shot attatched, any ideas please ?

[Mr. P]

I just have a curious question, why do you have universe 1 on one IP address and universe 2 on a different IP address? Are the two universes setup on different controllers? Not knowing your setup, IP addresses are assigned to controllers and not to individual universes.

 

As an example, if you set up a Pixcon16 on IP address 192.168.1.5 then all channels and universes on that Pixcon16 will fall under that IP address.

Edited September 27, 2015 by Mr. P

[santa25]

Hi Mr P, I am trying to get into the network config to change those addresses, but I keep getting the error message. I have sandevices e682 and e6804 controllers to add and also a 27channel dmx board, I have three lor cmb boards hooked up and working, just trying to add the others now, thanks

[Mr. P]

What is your LOR license level?

[santa25]

I have advanced licence

[santa25]

ok the error message has gone, so just need to set ip addresses for the controllers

[Mr. P]

Set the IP addresses on the controllers themselves then set the IP addresses in network preferences keeping in mind that the universe goes with its corresponding controller if using unicast. If you are using multicast then you don't set the IP address.