Jump to content
Light-O-Rama Forums

CMB24D on 30.6 volts?


Recommended Posts

I need to control some 30VDC leds and need a controller. I could either buy a Hanson Electronics WS2811 controller that takes pixel data and can control up to 36volts or I can use the second bank of m CMB24D. The power supply I have is a 30VDC one but I used the adjust thing to put it up to 30.5v , which is the average of what the original power supplies of the lights all put out. The power supply is regulated but I measured it as 30.56v.


Would the tiny bit damage my CMB24D or is it OK?

Link to comment
Share on other sites

  • The topic was locked
This topic is now closed to further replies.
  • Create New...