nmonkman Posted August 30, 2015 Share Posted August 30, 2015 When I am sequencing in S4 and I have the play range set to "visible screen" it plays the screen, stops and then for a quick second it is like it either plays again or something but it is only for a split second. It does this at the end of the sequence too. Not a big deal when I am sequencing, but this will be a problem if it does it during the show. Anyone else experiencing this? If need I can post a video with a dropbox link. Link to comment Share on other sites More sharing options...
dgrant Posted August 30, 2015 Share Posted August 30, 2015 I have not yet tried to duplicate what you found as I normally never use the "Visible Screen" play command. Normally I'll start/stop with the space bar while sequencing and go back to where I need or will use the play again button or whatever its called. The Visualizer now also has a stop/start function to the SE. During your show, the show player loads the entire sequence(s) and plays them based on the setup you provide to the shower editor. It has nothing to do with SE commands in the editing mode, so you should be just fine during the show itself. Link to comment Share on other sites More sharing options...
EmmienLightFan Posted August 31, 2015 Share Posted August 31, 2015 It is something in the sequence editor. It happens to me when I use play from selection. It doesn't happen in the show player. Link to comment Share on other sites More sharing options...
Recommended Posts