Servodog "light LED" moment

[queenidog]

I don't have my "light an LED" moment, that time when you do a very basic operation to test everything from hardware to software and I can't figure out what is wrong.

 

I have Servodog with USB converter.  My one connected servo works with ServoDog Utility and also the hardware utility (separately since the servodog is on the same port 14).  I have my servodog as device type Digital I/O Card, and unit 1.  (I tried LOR Controller and even DMX but same result.) When I run a short sequence to move the servo one way or the other, nothing happens.  My sequence has on, off and 50% intensity over a 2 or 3 second span.  I expect the servo to move one way or the other when the sequence is played.  It doesn't.

 

Any ideas on what is going on or where I'm going wrong here? 

 

I uploaded the *lms file.  thanks

testservo.lms

[queenidog]

I'll add to this topic instead.

 

I have my "AHA" moment!   Found, under the Play menu an option to "control lights".   Of course I'm thinking "control servo" so I ignored it.  This was the ticket: the sequencer now can control the servo.

 

  Thanks to those who may have wanted to respond...

Edited June 28, 2015 by queenidog