Todd_91 Posted December 2, 2014 Share Posted December 2, 2014 Here is the problem, I put a show on my SD card which is supposed to start at 5:00 and run until 10:00 along with the show I have the SD card set the time on the G3. Upon putting the card in the G3 it says the time is set then flashes "init" thethe wait which is fine. But when it is 4:59 the G3 locks up and does not start the show. The clock keeps time correctlybut it will not start. I put the show on another card which has a run on power up and the show runs just fine. I its not the SD cardbecause I have put the show on the same card with run on power up and it works fine. Any suggests would be great. Thanks,Todd Link to comment Share on other sites More sharing options...
Don Posted December 2, 2014 Share Posted December 2, 2014 Any chance the director thinks it's 5am, and not PM? There is a PM indicator on those units. Link to comment Share on other sites More sharing options...
Todd_91 Posted December 2, 2014 Author Share Posted December 2, 2014 The time is correct, when it got to 4:59 the unit just kept displaying 4:59 and then the correct time. Link to comment Share on other sites More sharing options...
Don Posted December 2, 2014 Share Posted December 2, 2014 The time is correct, when it got to 4:59 the unit just kept displaying 4:59 and then the correct time.It kept displaying 459 and then the correct time? I don't understand. Link to comment Share on other sites More sharing options...
Todd_91 Posted December 4, 2014 Author Share Posted December 4, 2014 FYI for anyone having this problem. It was a bad sequence which locked up the G3 Link to comment Share on other sites More sharing options...
Recommended Posts