Rabeiler Posted November 26, 2014 Share Posted November 26, 2014 Have one CCP string and one CCB string where only a few bulbs are working. On the CCP, the first 4 pixels work from the controller end and then the rest are out. On the CCB, the first 20 or so bulbs work and then the rest are out. I am thinking that it is either a bad pixel/bulb or a break in the wiring. These are several years old. I inspected the strings and can't see any visible signs of problems. I swapped strings on the controllers and verified that the controllers are working properly. Is it possible to buy just CCP and CCB strings? Link to comment Share on other sites More sharing options...
indi Posted November 26, 2014 Share Posted November 26, 2014 Have you tried to reset the controllers? Where you testing with the Hardware utility or did you try a sequence? Link to comment Share on other sites More sharing options...
Rabeiler Posted November 26, 2014 Author Share Posted November 26, 2014 The strings were tested using my normal sequences. The controllers are fine. I have 8 controllers (4 CCP and 4 CCB). I swapped strings on the controllers and the problem stayed with the strings. Link to comment Share on other sites More sharing options...
indi Posted November 26, 2014 Share Posted November 26, 2014 Sure sounds like the strings. You might start a help ticket and see if LOR can help. Link to comment Share on other sites More sharing options...
Rabeiler Posted November 26, 2014 Author Share Posted November 26, 2014 I have created a ticket - will see - probably going to have to buy some spares Link to comment Share on other sites More sharing options...
Recommended Posts